44 knuckle tapping [Archive]


Pirate4x4.Com > General Tech > General 4x4 Discussion > 44 knuckle tapping PDA : 44 knuckle tapping morpheus 10-02-2002, 08:12 PM hey, I found this image in an old post. what is the red X dimension ? is the one line just going to the center of the knuckles steering arm or are the numbers just purposeful for drilling the holes and the exact location isn't that big a deal. just be consistent on both sides ?? - jack Rogue Bronco 10-02-2002, 09:15 PM The X should be easy to get off a Chev knuckle that already has the holes in it. Keith 10-02-2002, 09:16 PM Depends on the style of arm used, the width of the arm, and where you want it to sit on top of the knuckle in order to clear the backing plate and the ball joint. Mechanos 10-02-2002, 09:22 PM These dimensions were pulled off of a Chevy factory drilled D44 knuckle. http://www.mo-4xtoys.com/torc/knbltpat.jpg morpheus 10-03-2002, 07:50 AM thanks TORC ! that's exactly what I was wanting to know - jack RustoleumWhite 10-03-2002, 07:54 AM hey TORC, you want to send me that CAD file when you get a chance... .dxf is fine thanks -mark IndyCJ 10-03-2002, 08:06 AM Originally posted by RustoleumWhite hey TORC, you want to send me that CAD file when you get a chance... .dxf is fine thanks -mark I wouldn't mind that either, if it's ok. Thanks! 4Bangler 10-03-2002, 08:31 AM Oooh, me too! Mechanos 10-04-2002, 08:01 AM files have been sent out to those who wanted them......