Anybody have close up pics of car ramps on the neck of their G/N trailer?

My trailer looks like this.
http://t0.gstatic.com/images?q=tbn:XPB0wAn3zBDs1M:http://images01.olx.com/ui/3/57/30/56725730_1.jpg


I also have a 3ft. dovetail and would like to see ideas for extension ramps off the back.



This isn't a weight problem but a length problem.

Nobody has ramps front or rear?

Nobody has ramps front or rear?

Most people wont admit to having a length problem.

Most people wont admit to having a length problem.

You are right. Besides that, if he had any kind of rock crawler he wouldn't need any ramps.

You are right. Besides that, if he had any kind of rock crawler he wouldn't need any ramps.


Have you ever thought that you can haul more than a 4x4 on a trailer?

While I'm sure everybody would love to have a 40+ ft trailer, being able to extend ramps a few feet or place one of the vehicles on the neck is mighty handy when you only haul multiple vehicles occasionally.

Dumbass.

:shaking:

i plan on building an upper platform so i can more easily squeez 3 rigs on my 36 foot GN after i build the platform ill use roundstock and angle iron to make the ramp mounts,just like i did at the end of the trailer.

what are you wanting to see in the pics?

The neck of my trailer is very similar to this one.

http://www.dktrailers.com/trailers/Deck%20over%20Flatbed/large_photos/gooseneck.jpg

I was looking for different designs folks may have been using to put ramps onto the neck. Ideally, the ramps would be able to be removed if I needed the entire flat deck.

I am also curious about tie downs.

For the dovetail ramps, my dovetail is very similar to this one.

http://images02.olx.com/ui/3/31/74/f_50832774-c9b5bfea.jpeg

I am going to add another ramp in the middle and then plate across the bottom of the ramp so I can park on that if I need a flat deck. I figure I can always find a loading dock somewhere to load and unload as I only carry two vehicles when I am working around the city which has plenty of loading docks.


But I also want to modify the ramps a little bit so I can remove them all together and then add some extension ramps if I needed an extra foot or two.


I have thought about lengthening the trailer 10 ft to solve all my problems and add a 3rd axle to bump my weight up to 21k but want to explore these options first before I take the even more complicated route as a 30+3 G/N is harder to drive, maneuver, and store than a 20+3.

Anybody have close up pics of car ramps on the neck of their G/N trailer?

My trailer looks like this.
http://t0.gstatic.com/images?q=tbn:XPB0wAn3zBDs1M:http://images01.olx.com/ui/3/57/30/56725730_1.jpg


I also have a 3ft. dovetail and would like to see ideas for extension ramps off the back.



This isn't a weight problem but a length problem.

Damn Thats a tiny trailer!

Damn Thats a tiny trailer!

Yea, I tow it behind this.
:flipoff2: