|
: :smokin: Dog House 10-03-2002, 07:46 AM Hey you guys guess what showed up from England yesterday! :bounce: :bounce2: Got 40MM square slide pumper carb? I can't wait to bolt this mutha fawka on. Who's yer daddy bieotch:question: :D Dog House 10-03-2002, 07:47 AM Flip side. YJ4RoX 10-03-2002, 09:21 AM nice man, only one question? whats with the fraction to decimal conversion chart in the background. U should have that shit memorized by now. :flipoff2: I used to have one in my office too:D Dog House 10-03-2002, 09:31 AM I took the photos in the metrology area. Memory? What's that? I've consumed too many :beer:s and such :smokin: that now I suffer from CRS. :laughing: I hope I can remember where I parked my bike this morning! Originally posted by YJ4RoX nice man, only one question? whats with the fraction to decimal conversion chart in the background. U should have that shit memorized by now. :flipoff2: I used to have one in my office too:D TDW 10-03-2002, 08:56 PM Can you look up a phone number for me? :flipoff2: :D Dog House 10-04-2002, 06:41 AM :laughing: :shaking: I knew it was just a matter of time before someone made a wise crack about the Smart Scope's monitior stand. :flipoff2: I got tired of a kinked neck after inspecting tons of parts. Some of our tools have upwards of a hundred cavities. That's a lot of parts to inspect with typical sampling procedures! Edit: I forgot to mention that in the second picture if you look at the pump linkage you can see that the spring loaded screw on the left is for adjusting when the pump kicks in. The vertical one that's difficult to see adjusts how much the pump blasts in to the engine. So in other words, back out both screws and hang the fawk on! :eek: ;) Jimmy :massey: | |