Anyone know what size nut I need to make the special tool to adjust, set backlash on the 9.25 axle? Thanks

I'll sell you one that's been used 1 time $25.00 + shipping, pm me,,,

No thanks.

I've read that you can use the hex end of a dodge car torsion bar if you have one handy.
Travis..

~1" Nut IIRC will work, might need to hit it with a flapwheel to knock the edges off a bit.
Use a piece of allthread or weld on an 1/2" drive extention.

You can buy one for ~$25 from East Coast Gear Supply:
http://eastcoastgearsupply.com/i-129818-chrysler-7-25-8-25-9-25-side-adjuster-tool.html
498320

Torsion bar worked for me just fine.

Thanks for the info. Went out and bought a 1'' nut for $2. Had a piece of tube and an old 1\2'' socket laying around. Looks just like the one in the pic. :p

you thieves that is patent pending :flipoff2:, they are a bit gangster but they are functional. make a second one so you don't have to fish it out and take it to the otherside