Well i searched and didnt find much so.....

Anyways, i broke the T case adapter, 400 turbo to D20...
My ? is this.. can i fix it?
Pretty sure its aluminum adapter..
Where i broke it is, where it bolts to the skidplate, one of the 2 bolts, the one more towards the drivers side sheared off, bolt stayed in but where it vracked pulled half of the part that threads onto the bolt off and now jus have a lil chunk..

If anyone has any info or any help at all would be greatly appreciated..

Anyone??

You could try a certified welding shop.

This is a pretty wide pad. if you lost just an inch off the end which it sounds like, you could either weld it back on or just drill and tap a new hole just inboard of the old one and fab a mount to go with it.

This type breakage usually happens when your motor mounts are "loose" and the tranny mount is "tight". check it out or you'll just break it again. good luck!