While on 'tour' I decided I needed a way to move the axles around the shop... It was annoying to keep walking around the saw horses.

So, I needed a rack to hold 3 - 2 to go into the next project, and then 1 when it gets pulled out.

I had some casters from an abandoned project, and the steel was scrap and leftovers from buying full lengths and the wood some 2x8 scrap.

The casters are a bit small for 3 axles, so I probably won't push it around much fully loaded.

Cool...And I thought i was cool putting mine on these with notches cut in 2x6

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=38970

Nicely done.

Since I was asked in a PM, <Norm> Here is a measured drawing. For more measure drawings see the credits at the end of the show. </Norm>