Ok, bottom line is I hate wiring. What I have is a 90 K5 with a 350 TBI. It is getting hacked, tubed, and the dash is gone. I am also removing the stock steering column. I know I can buy a aftermarket harness to run the FI but I don't want to spend a few hundred bucks to get basically what I already have. Does anybody know of a place that will modify my harness? I will be getting rid of the vss and also need a "check engine light" for the codes. I searched online but couldn't come up with anything except premade harnesses. Here is what it looks like now and I don't need much wiring for anything else because I will only need a ign and starter button, and it will have 3 guages. Oil pressure, coolent temp, and volts.

http://photos.imageevent.com/btsnpcs1990/bitsnpiecesbuild/thenextphaze/websize/003_2.JPG

Search out Texican over on the Cruiser forum. He has a good writeup of a swap he did in a Cruiser w/TBI'd 350. I'm going thru the same, I was able to get a booklet from Downey that listed the different computers and how they were wired. Really not that bad. Actually should be easy considering how easy yours would be to access, from looking at the pic. Try Colorado K5, or taildragger.com/K5/TBI. Should be able to save a few bucks this way. HTH, Al

Do a search under my name... I gave a system by system break down a few years ago. Color and pin outs with pictures:eek:

Here's a great thread on TBI.
http://67-72chevytrucks.com/vboard/showthread.php?t=317519

Actually this is easier then I thought. Howell is going to burn me a chip that will take out the VSS and what ever else I don't need. The check engine light is simple to hook up too. I should be good to go.

http://www.pirate4x4.com/forum/showthread.php?t=432269
Do a search under my name... I gave a system by system break down a few years ago. Color and pin outs with pictures:eek: