Do you have anything as far as internal axle seals at the carrier for your 9 inch housings?

something like this
http://www.spidertrax.com/s.nl/it.A/id.2467/.f?sc=2&category=5089

Would the above seals work in your housing?

minus drilling and taping a hole for the keyway.

Anything planned in the future for this?

I am interested in the provision for a front axle seal. Purchasing housings is something I want to do in the next two weeks and I am seriously considering yours.

I think you will be happy with the response you will get. Im putting them in our Ballistic axles we are selling :)

I think you will be happy with the response you will get. Im putting them in our Ballistic axles we are selling :)

So Ballistic makes something or did you use spidertrax's?

We have the same seals everyone else is using, by the end of the week we'll have pricing and info on some blinging new aluminum carriers.

Thanks - Jeff

Is there a pic or a link to the seal you are refering to?

You are not wasting your time if you do, I am ready to pull the trigger on a front and a rear this week.