Ok I'm finally breaking down and thinking of getting a plasma cutter. I've anrrowed it down to two choices and I was wondering which would everybody recomend? also, they are both 120v machines right?( think I'm reading the spec sheets right), which is regular houshold current or is it wishful thinking on my part?

number 1:http://www.cyberweld.com/pow650plascu.html

number2: http://www.cyberweld.com/spec375cut.html

the first one requires a 220 volt single phase power source, the second one is switchable between 110 volt andc 220 volt. I would personally reccomend looking for a new or used Thermal Dynamics unit, they're very well built, and have good customer service.

i got the miller.. i've cut half inch thick plate with it.. it's awesome :D