|
: Custom Long Arms . Thoughts on the UCA scottv 10-09-2002, 11:25 AM OK I about got the Lower Controls arm designed for my Long Arm's So I am starting to think about the Upper's i.e. Lenght... Where to tie them in and so on. Any Suggestions This is on a XJ And Yes I searched Thanks Scott StudNuts 10-09-2002, 01:24 PM You could run a rear wishbone, a custom flat skid plates make an excellent base for uca mounts. Or triangulate the uppers in rear and make some link attachment tabs, or buy them from avalanche. scottv 10-09-2002, 04:48 PM this is on a XJ..........Only has them in Front notJoeKing 10-10-2002, 07:54 AM Where are you tying them into, the LCA (RE style) or the subframe? Keeping the front trackbar? If it's just the subframe, make 'em as long as possible and parallel to the lowers to prevent binding. If your going RE style, just copy what they've got... scottv 10-10-2002, 08:26 AM If I go RE Style Can I loose the Trackbar thornhill 10-11-2002, 01:59 PM If I go RE Style Can I loose the Trackbar No, you have to keep the trackbar in the front Unless you triangulate the uppers and then you'd have to go full hydrolic steering. You don't want to have to do that:D NE-RokToy 10-11-2002, 03:29 PM Originally posted by thornhill No, you have to keep the trackbar in the front Unless you triangulate the uppers and then you'd have to go full hydrolic steering. You don't want to have to do that:D close but still wrong, you can triangulate and just get the draglink as close to parralel as possible and it will steer fine (if you don't beleive me look at something with leaf springs in the front) | |