Has anyone tried to adapted a flange from a Toyota drive shaft to a D44
front or rear.


I searched, and didn't find what I wanted.

you have two choiced here

high angle driveline sells a flange that is a D44 yoke that let's a toy driveshaft bolt right to it, or you can get a conversion u-joint to put in it's place

jess sells the flange's for 139 or somethign like that?

A toy cv can be redrilled for the large patern zuk tcase.......the other end needs to be a 1310 ujoint though for the D44...

Arizona Dline does this all the time......So im sure that jess can!

yha the 1310 to 'yoda joint sux tho.. the 1310 side is weeker, and it limits driveshaft angles..

joda joint is much stronger and ez to find if you need to replace.. the conversion joint isnt...

buy the flange..