Hello,

Does anyone know where I can lay hands on a AW4 valve body?


Thanks
Dean

I've got at least one extra one laying around. You do realize that they are not all the same though?

Yes, I realize that they aren't all the same but I'm pretty sure that the one I have doesn't have the check balls in the right places and I can't tell where they go so I'm looking for a replacement.

Any ideas?

Dean

Yes, I realize that they aren't all the same but I'm pretty sure that the one I have doesn't have the check balls in the right places and I can't tell where they go so I'm looking for a replacement.

Any ideas?

Dean

What year trans are you working with? This is the diagram from the AW4 rebuild manual I have

That's a good question? It came out of a 91 Cherokee but if I set it up like the AW4 manual says to the tranny acts like it's in gear even in park and neutral. I tore the valve body off and checked the clutches but they all seem to shift correctly and have the correct amount of free play in the disks. So I'm kinda stuck.

Dean

Your diagram looks diffrent than the one I have. My plate doesn't seem to be setup to run the ball in the bathtub port or at least there isn't a seat machined into the seperator plate

If I have time I can take a look at teh one sitting in my shop. Should be from an 87-90 since it's got a 21 spline output on it. Pretty good chance that it's the same as a 91.