Ok, kinda 60 dumb so here goes..

Kingpin right? What do people do with u-bolts on this, chop the webbing below and just use a round u-bolt? What plate? Looking at the ballistic steering arms http://www.ballisticfabrication.com/D60-high-steer-kit-for-kingpin-axles_p_1246.html

Anything I should know about putting these on and should I order anything different than the "standard" arm?

Thanks :homer:

the factory ubolts point down.

the arms you linked are springless arms, remove the spring and install your new arms.


stop drunk posting.

Obviously the factory bolts go down, just looking for the best solution to make em go up :p

2 options, grind a slot or drill a hole.

thanks, that's what I figured just thought I would check to see if there was some fancy other solution first.

you could just use the factory stuff on left side and flip the square u bolts in chuck so they point up and use a spring plate. i have done it it worked out good for me i still have the dana 60 chuck for the driver side that i might be willing to part with for the right price. pm me

the plate I PM'd you about Brandon is for the ubolts pointing up.

the plate I PM'd you about Brandon is for the ubolts pointing up.

Didn't realize that, I just bought a setup from Dan at ruffstuff


thx

On my 60 swap a few years ago, I drilled a hole in the webbing. It looks much cleaner that way.

On my 60 swap a few years ago, I drilled a hole in the webbing. It looks much cleaner that way.

that looks good