here's a link to a thread about the way I installed a 3.0 forged joint. The question is should the joint be rotated to change the orientation of the side loading?

http://pirate4x4.com/forum/showthread.php?t=880034

I read this:

Either joint will hold up to an axial load. I tried to kill both, but the 2.63" Ballistic joint ball just mushroomed and the part stayed intact. The billet rod ends uses a hardened ball, so I'm not sure what would give first, but I do know that the 20T press was not enough to even phase it.

and here's the joint in question:

Can I get a different (larger) view please - Jeff

Sure, the whole axle...or can I swing by the shop...

Frank

I'm not going to be around here for a bit, wife is being induced of Friday morning...

I looked at your other thread and I understand the concerns but others, but I'd still like a picture that is taken from a position further away as well. Thanks.

I'll get you one tomorrow...

Thanks and BEST WISHES JEFF on the new baby!

i am interested in knowing this myself. i was planning to use one of your 3in joints in the same orientation.

Can I swing it by the shop tomorrow?