|
Ibuildembig 04-22-2010, 07:49 PM I have a single wheel Dana 80 in my project and I'm concerned I might run into clearance issues with tires, so I was curious if anyone knew or could measure the width of their dually truck to see how much wider they are. Thanks DSLstuff 04-23-2010, 06:03 AM I think they are ~2" wider. This is an axle out of a standard 3500 not a cab and chassis truck. A cc truck dana 80 is narrower than the SRW axle. Ibuildembig 04-23-2010, 07:18 AM That's not too much then..I know on the Ford duallys its about 4 or so. So on a dodge the chassis cab rears are narrower than a single wheel? Whoda thunk it lol.... PapeCAT 04-23-2010, 09:10 AM The C&C axkes are narrower than a standard Dually axle but wider than a SRW for 1st gen pre 1993 trucks. Not sure why this would be different for the later trucks Ibuildembig 04-23-2010, 10:04 AM Mine came from a 94 2500 2x4...I am putting it under a 68 Ford Crew Cab with peterbuilt rear suspension. I wanna run 285/70/19.5 duals on it, and I was just curious what the widths were in case I was too narrow. | |