Here it is guys the ORIGINAL universal 4 link and 3 link brackets. What makes ours better than those other guys who copied our design is that we now use an L shaped bracket to accommodate frames taller than 4".
They are designed for 2 5/8" mounting width and a 9/16" bolt. for Johnny Joints or Heim Joints with spacers.


***Universal 4 Link Brackets*** (http://www.polyperformance.com/shop/Universal-4-Link-Frame-Mount-Brackets-p-1988.html)


***Universal 3 Link Brackets*** (http://www.polyperformance.com/shop/Universal-3-Link-Frame-Mount-Brackets-p-1965.html)

4 Link Brackets

http://www.polyperformance.com/shop/images/D/PPM-5006-01-Anim-400.gif

http://www.polyperformance.com/shop/images/D/PPM-5006-01-400.jpg

3 Link Brackets

http://www.polyperformance.com/shop/images/D/PPM-5006-02-v2-400.jpg

http://www.polyperformance.com/shop/images/D/PPM-5006-02-v2-D1-400.jpg

Shoot me a PM or E-mail to Tommy@polyperformance.com for Fastest Response. Or Post Up

what is the link separation between the 3 upper holes and the lower hole on the 4 link bracket?

what is the link separation between the 3 upper holes and the lower hole on the 4 link bracket?

3.5", 4.5" and 5.5".

Will the Poly 4 link rear work with the BTF back half frame kit? i just want to make sure i wont have an issue with the links hiting the frame.

Thanks

I don't see any reason why it would not work. Looks like it's cut behind where the upper/lower link brackets will mount. I'd say go for it.

i ask only becuase the BTF kit angles in right about where links get close to touching normal frame.

Yeah I have seen the kit and it does look close. It looks like even with the lower link level and touching the frame the upper tabs would be very close to the tub anyways. If you can get some measurements of the backhalf I can compare to a TJ we have here and check to see if it will work for sure tomorrow. Shoot me a PM. Thanks.