|
: looking for 3 link mount on top of diff flmanyj 10-18-2002, 05:03 PM does any one have any pic of what they did on top of the diff for there 3 link like a ford radius arm bushing or a jonney joint i was thinking more of the bushing i know Wolf359 has some thing like that elf_cruiser 10-18-2002, 05:09 PM BellyDragger has a nice setup. I believe it's a 1" heim mounted sideways, with high masalignment spacers that reduce to a 9/16" bolt. Maybe he can post some pics. yager 10-18-2002, 05:47 PM Here's an thoght, similer to the sidekick, rear upper "ball joint" that connect the upper link... Couldn't you use a threaded insert for a large threaded ball joint (upgrade part used in circle track/dirt cars), Then just use a mount with a taperd hole mounted somewhere.... not sure which way would be better to point it all.... see speedway or other roundy round catalog.... or use a 3/4-1 ton tie rod end to a link like the 1" heim mentioned. Maybe a low(er) buck solution.... just a few thoughts..... -yag flmanyj 10-19-2002, 03:34 AM thats a good idea thanks redrangie 10-19-2002, 06:05 AM All coil land rovers use a ball joint 3 link in the rear. A arm to Ball joint link. Picture attached of stocker a arm. NOT my rig. Also check the Rover board, as some have made a 3 link that top mounts for the front on there own. There is a company that makes a 3 link out of the box, but it is a bottom mount. mrtwstr 10-21-2002, 07:27 PM Look at the rear of the Willys. wwwtriple-xtraction.com Toddy 10-21-2002, 09:29 PM Look at Erocc pics and I think the supercrawl pics for the little tube sammi from badlands off raod. I am almost postive that it had a johnny joint set up you are looking for. | |