okay so i seen in a 4x4 mag (dont remember what 1) a dana 80 with these flanges on the axle tube so that you can clock your inner c's (knuckles) and i was thinking if you guys made the flanges with the correct inside diameter holes and the machined gasket surface this would really open up the world of front axle swaps for the dyi'er


edit: the dana 80 mentioned had dana 60 c's and crap on it for the steering

The article references Custom Differentials in Bloomsdale MO, give them a call -

Jeff

thanks for the quick response i have tried yesterday and today to get ahold of them with no avail are they on pirate? also where you not interested in making some? some kind of copyright? or jus not up your alley? this other place never answers there phone and it looks like there shit is all really pricey
i have seen your guys work and customer service and i feel your company has a better chance of putting something out there that i would buy your prices are the lowest in the industry and you seem very commited to the 4x4 seen
i was thinking that the (flanges) would be great for the 44/60 60/9 60/14 swaps because one side flange can have the 3.5" hole and the other side could have the 4' or whatever the axle tube dimensions are also it would seem to be a simple cut tube press on flange weld up then bolt up kinda thing no real worries about pinion angle and caster i was even think a step further and you could offer it as a kit which could have a dana 60 c already welded in 1 half

Bump

I too am interested in the outcome of this Ida.

Nat

Not interested, thanks - Jeff