: Engine running hot


coyote
10-20-2002, 07:45 PM
Got a 350 that is running hot, I flushed the system and tore the front end down to verify valve timing...all looks good, have a edlebrock water pump and running a 5/8's orfice for t-stat...what else to check while its down...the rest looks good do far..at 8 btdc on advance at idle...though about pulling the intake gasket as when I spray propane directly in the port vacuum I get no increase in rev's...plugs are mixed between greyish and showing signs of excessive idle.....any other thoughts?

iscout62
10-20-2002, 08:31 PM
Collapsing hoses can make things hot.

coyote
10-20-2002, 08:35 PM
running rigid hoses with fixed elbows...someone already mentioned it earlier...

Scout Dude
10-20-2002, 08:38 PM
You live in Arizona, of course it's running hot:flipoff2:




What radiator? When is it over heating- Freeway, idle? What fan- Electric, clutch, flex? We need more info...

elf_cruiser
10-20-2002, 08:55 PM
FJ-60 radiator, hoses are good, steel fan, ??6 blade??

pipefitter
10-20-2002, 10:07 PM
Try washing the radiator out . If it is dusty outside you can get dirt and trash in the holes that go thur the radiator . This will cause you to over heat . I had the same thing with my truck when I would work on job sites when they were doing ground work and the dirt was flying .

JIM3030
10-21-2002, 12:30 PM
8 times out of 10 it is lack of fan shroud. or not in the proper place. letting it pull air from every where except through the rad.

TRD
10-21-2002, 12:52 PM
it is overheating because you have a cruiser. Mine has always over heated. 4-core radiator + Strong electric fan + heater on + freeway (or anywhere for that matter) = over heating. I am going to see if TBI will help fix it (timing + tune up). Good luck

coyote
10-21-2002, 02:51 PM
Ya I've heard that before...that's why I'm going to tear it down and rework the shroud...I've seen Cruiser cool just fine so I know it can be done just not sure what step is next...

Thanks, Matt

The Jerk
10-21-2002, 02:54 PM
Originally posted by TRD
it is overheating because you have a cruiser. Mine has always over heated. 4-core radiator + Strong electric fan + heater on + freeway (or anywhere for that matter) = over heating. I am going to see if TBI will help fix it (timing + tune up). Good luck lol, mine runs fine, no inner fender, griffen small rad, and only a black magic elec fan. suck it! jiMMy fine = 190 ish

coyote
10-21-2002, 05:29 PM
Jimmy, Can you snap a picture of you inner trimming of the wells....I opened mine but mabe I need to get at it more....