Mark19382
06-17-2010, 01:48 PM
This decision to sell my Torchmate setup brings me great sadness as I have thoroughly enjoyed working with it over the last few months. It has exceeded all my expectations and has been a “blast” to work with! The people at Torchmate, from their sales team to their technical support team, have been great to work with. However, due to family circumstances in need to convert my garage into an apartment for my aging mother and I need to clear out all my stuff…
So here is what I have:
Torchmate 2x2 Paid 1995.00
-with water table
Torchmate machine torch holder Paid 175.00
Torchmate CADLite Paid 250.00
Torchmate Routing Package Paid 770.00
BobCAM 3-D Software Paid 495.00
Hypertherm PowerMax 45 cutter Paid 1559.00
-with hand torch
Hypertherm Machine Torch Paid 406.00
Hypertherm CNC interface cable Paid 45.00
Hypertherm FineCut Consumables Paid 75.00
Millermatic 140 + cylinder Paid 870.00
CH 60 Gal Air Compressor Paid 400.00
DeVilbiss QC3 Air Filter & Dryer Paid 151.00
Total Paid $7,191.00
I am hoping to find someone who would like the whole setup. If so, I would let everything go for only $5,500.00. I really can afford to go much lower as I now need the money to convert my garage into the apartment (carpeting, kitchen cabinets and appliances, bathroom fixtures, etc.).
I am located in West Chester, PA (about 30 minutes west of Philadelphia). If anyone has an interest, please feel free to contact me. Right now everything is still connected and fully operational for you to check out. If it helps I could spend a little time showing you some basic how-to stuff to help you get started.
Thanks for your consideration,
Mark
So here is what I have:
Torchmate 2x2 Paid 1995.00
-with water table
Torchmate machine torch holder Paid 175.00
Torchmate CADLite Paid 250.00
Torchmate Routing Package Paid 770.00
BobCAM 3-D Software Paid 495.00
Hypertherm PowerMax 45 cutter Paid 1559.00
-with hand torch
Hypertherm Machine Torch Paid 406.00
Hypertherm CNC interface cable Paid 45.00
Hypertherm FineCut Consumables Paid 75.00
Millermatic 140 + cylinder Paid 870.00
CH 60 Gal Air Compressor Paid 400.00
DeVilbiss QC3 Air Filter & Dryer Paid 151.00
Total Paid $7,191.00
I am hoping to find someone who would like the whole setup. If so, I would let everything go for only $5,500.00. I really can afford to go much lower as I now need the money to convert my garage into the apartment (carpeting, kitchen cabinets and appliances, bathroom fixtures, etc.).
I am located in West Chester, PA (about 30 minutes west of Philadelphia). If anyone has an interest, please feel free to contact me. Right now everything is still connected and fully operational for you to check out. If it helps I could spend a little time showing you some basic how-to stuff to help you get started.
Thanks for your consideration,
Mark