i know this has been brought up before in other threads, and i'm not sure i really caught the answer. what settings need to be changed to get the machine to cut right?

i know this has been brought up before in other threads, and i'm not sure i really caught the answer. what settings need to be changed to get the machine to cut right?

should be listed under configure, system, motor signals. Depending on the machine they have to be set a certain way. I have a 2x2 with a router setup and they're all set to positive. I believe I had to change the Y axis signal to positive for my setup

Regards MH

i guess i should have mentioned that i have a 2x2 with a plasma. i'll give that a try

i swapped my X and Y axis and made them both positive...so now when i look at my machine overtop of the monitors...i see the same thing as on screen. It was way too confusing to have it mirrored and turned 90 degrees compared to how it showed on screen.

There is a 2x2 plasma setup file on the CD that shipped with the machine under the folder setup files. Make sure you are using this setup file, copy it to the Torchmate Data/Torchmate 3/Setup folder and then on the driver software click on File, Open Setup File and select the 2x2 plasma.stp.

There is a 2x2 plasma setup file on the CD that shipped with the machine under the folder setup files. Make sure you are using this setup file, copy it to the Torchmate Data/Torchmate 3/Setup folder and then on the driver software click on File, Open Setup File and select the 2x2 plasma.stp.

i've done this, does it need to be run every time?

Yes, if you moved the file to the hard drive then each time the driver software starts up it will pull the setup information from this file. At the top of the screen on the driver software it will tell you what setup file you are using.

i've done this, does it need to be run every time?

Yes, if you moved the file to the hard drive then each time the driver software starts up it will pull the setup information from this file. At the top of the screen on the driver software it will tell you what setup file you are using.

Make sure that it is being read from the hard drive and Not the CD, otherwise you would need the CD to be in the machine in order to run the table every time, and any settings you did change in the setup file wouldn't get saved.