Stix&stones
06-22-2010, 07:51 PM
I just brought this up here to Ontario, from California in the early spring, it's NEVER seen SALT or a winter with snow. This is just a solid as it rolled of the production line, there is NO rust anywhere. I don't want to sell this but I just don't have the time to use it. Located just north of Toronto Ontario.
The specs are below.
1990 Toyota SR-5 4Runner
items listed in no particular order
*22RE engine recent tune up, (176,500K miles)
*Full custom 2.5" stainless exhaust from engine back with header & high flow cat. Comes with valid Ontario etest.
* R151 Turbo 5-speed (out of a 87 Toyota , 4.30 1st gear)
*dual 23 spline transfer cases, (crawler box has 4.7 marlin spiral cut gears, marlin installed them himself & main t-case has 4.0 AA gears) Marlin's twin stick and custom transfer case parking brake
* custom rear CV driveline
*14" long travel front driveline
*Marlin Turtle tuff crossmember/skid plate
Trail gear hydro assist steering, with PSC power steering pump.
* 90' Dodge gas ¾ ton HD rear Dana 60 axle, (30 spline FF axles), drum brakes, 5.89 gearing ARB, custom top track bar mount, 2" billit alumn. wheel spacers, upgraded 9/16 wheel studs.
*78 GM ¾ ton HD Dana 44 front axle, housing has been cut/rotated (for better front driveline angle, and good castor), longside tube cut down 2.25"s, Warn axle shafts inner/outer, leftside CTM u-joint, right side Longfield u-joint, 5.89 gearing, ARB, 2" wheel spacers, HD Warn locking hubs.
*front BDS double military wrapped 3.5" lift springs for a Jeep YJ (lifetime warranty)
*custom 2" front drop box with winch points
*boomerang front shackles
*HD solid 1" dia. Tie rod/draglink
*custom 1" lift right side steering arm
*Rancho RS 9000 front adjustable shocks (the longest ones they make)
*Marlin front shock hoops
*extended front brakelines
*yellow top Optima battery with custom battery shut off
*a pair of rock lights
*blue l.e.d under hood lights
*Warn X8000I winch with purple synthetic line, Daves off-road winch fairlead
*Dick Cepek Super Off-Roader driving lights
*custom to fit Rubicon Express Jeep TJ rear swing out spare tire carrier
*Q-78 spare tire
*17x9..5 Allied steel bead locks
*13.5x39.5x17 SS IROK tires (70% tread left)
*rear RS 9000 9012 shocks
*rear 5.5" lift Alcan 53" long springs with custom double swing shackles and ramped front hangers
*raised gas tank (2.5"s)
* 3" bodylift
*custom rear wrap around bumper with receiver
*FULLY custom EXO cage (1 of a kind) built by Monkey Bars in Loomis
*custom sliders with 1" square inserts for steps
*Sony stereo/cd with 2-4"speakers, 2-6`` speakers, 2-6x9 speakers, 2 amps and a 10" sub
*Cobra Cb radio
*custom lowered center tranny hump
*12-Volt Guy flip rockers for off road lights/rock lights
*super clean interior
* ice cold a/c
*tilt
*rear heat
*int. wipers
*removable rear mud flaps
*spare parts include: spare rear axle, spare front stock short side axle, spare rear cv driveline & space CTM joint.
* Marlin Crawler, Cryo'ed t-case out put shaft
*********4Runner in great cond, you won't find another in this kind of shape in Ontario or the northern US!!!
********* Super clean interior
*********Final rockcrawl ratio is, 4.85 to 1
********* 6-page feature in CRAWL MAGAZINE (Issue #1
Nov/Dec 2005)
****** Winner of the 4Wheel Parts Magazine "Before
and After" monthly contest
Only issues are:
1.5" dia. dent in driver side rear door (see above
for spare door) crack in front windshield on driver side (only aprox 8" up from bottom) A dent in the rear tail gate; rear window still rolls down without a problem.
I also just installed a pair of Corbeau baja RS seat with covers, along with the beadlocks, PSC pump, new exhaust and intake...
I'm looking to get around $11,000.00 (CAN) obo, to cover most of my costs or would consider an ATV + cash, fox body 5.0 mustang (in good shape) + cash, or try your trade + cash.
The specs are below.
1990 Toyota SR-5 4Runner
items listed in no particular order
*22RE engine recent tune up, (176,500K miles)
*Full custom 2.5" stainless exhaust from engine back with header & high flow cat. Comes with valid Ontario etest.
* R151 Turbo 5-speed (out of a 87 Toyota , 4.30 1st gear)
*dual 23 spline transfer cases, (crawler box has 4.7 marlin spiral cut gears, marlin installed them himself & main t-case has 4.0 AA gears) Marlin's twin stick and custom transfer case parking brake
* custom rear CV driveline
*14" long travel front driveline
*Marlin Turtle tuff crossmember/skid plate
Trail gear hydro assist steering, with PSC power steering pump.
* 90' Dodge gas ¾ ton HD rear Dana 60 axle, (30 spline FF axles), drum brakes, 5.89 gearing ARB, custom top track bar mount, 2" billit alumn. wheel spacers, upgraded 9/16 wheel studs.
*78 GM ¾ ton HD Dana 44 front axle, housing has been cut/rotated (for better front driveline angle, and good castor), longside tube cut down 2.25"s, Warn axle shafts inner/outer, leftside CTM u-joint, right side Longfield u-joint, 5.89 gearing, ARB, 2" wheel spacers, HD Warn locking hubs.
*front BDS double military wrapped 3.5" lift springs for a Jeep YJ (lifetime warranty)
*custom 2" front drop box with winch points
*boomerang front shackles
*HD solid 1" dia. Tie rod/draglink
*custom 1" lift right side steering arm
*Rancho RS 9000 front adjustable shocks (the longest ones they make)
*Marlin front shock hoops
*extended front brakelines
*yellow top Optima battery with custom battery shut off
*a pair of rock lights
*blue l.e.d under hood lights
*Warn X8000I winch with purple synthetic line, Daves off-road winch fairlead
*Dick Cepek Super Off-Roader driving lights
*custom to fit Rubicon Express Jeep TJ rear swing out spare tire carrier
*Q-78 spare tire
*17x9..5 Allied steel bead locks
*13.5x39.5x17 SS IROK tires (70% tread left)
*rear RS 9000 9012 shocks
*rear 5.5" lift Alcan 53" long springs with custom double swing shackles and ramped front hangers
*raised gas tank (2.5"s)
* 3" bodylift
*custom rear wrap around bumper with receiver
*FULLY custom EXO cage (1 of a kind) built by Monkey Bars in Loomis
*custom sliders with 1" square inserts for steps
*Sony stereo/cd with 2-4"speakers, 2-6`` speakers, 2-6x9 speakers, 2 amps and a 10" sub
*Cobra Cb radio
*custom lowered center tranny hump
*12-Volt Guy flip rockers for off road lights/rock lights
*super clean interior
* ice cold a/c
*tilt
*rear heat
*int. wipers
*removable rear mud flaps
*spare parts include: spare rear axle, spare front stock short side axle, spare rear cv driveline & space CTM joint.
* Marlin Crawler, Cryo'ed t-case out put shaft
*********4Runner in great cond, you won't find another in this kind of shape in Ontario or the northern US!!!
********* Super clean interior
*********Final rockcrawl ratio is, 4.85 to 1
********* 6-page feature in CRAWL MAGAZINE (Issue #1
Nov/Dec 2005)
****** Winner of the 4Wheel Parts Magazine "Before
and After" monthly contest
Only issues are:
1.5" dia. dent in driver side rear door (see above
for spare door) crack in front windshield on driver side (only aprox 8" up from bottom) A dent in the rear tail gate; rear window still rolls down without a problem.
I also just installed a pair of Corbeau baja RS seat with covers, along with the beadlocks, PSC pump, new exhaust and intake...
I'm looking to get around $11,000.00 (CAN) obo, to cover most of my costs or would consider an ATV + cash, fox body 5.0 mustang (in good shape) + cash, or try your trade + cash.