whats the general consensus on front push to clear 40 to 43's on the front of an 80. I know its somewhat lift dependent, so figure medium sized lift at best.

Was thinking like 5", but would like to go a little less if I think I can get away with it.

I didn't stretch my 800 at all.

look at my build,i pushed about 8 in the front with my 42's. 60 front on FJ lift springs and you can see the pics flexed up with the backhoe at full stuff up front.at full stuff i had about 1/2 an inch tire clearence,it might get better or worse if air'd down,we'll see. some day.

I put 42" on the war pony, but I did do some fender mods front and rear. They seem to fit O.K. The wheelbase is 110" so about 1/2 and 1/2, on the strech.

I didn't stretch my 800 at all.

do you even have a frame left?

I put 42" on the war pony, but I did do some fender mods front and rear. They seem to fit O.K. The wheelbase is 110" so about 1/2 and 1/2, on the strech.

any chance I might swing through the 'ville one morning and take a look?

do you even have a frame left?

This was back in the day when I had a full frame 800.

This was back in the day when I had a full frame 800.

WAY back in the day :laughing:

I pushed out 3 inches for my 37's but I think I could run 40's without too much issue