how much psi does your avg saginaw p/s pump put out ?? any other brands put out more or less ?

someone posted in a bender thread about the possibility of using one to power a ram on a bender and was wondering what the possibilities of it are ... any info appreciated ...

- jack

My Tom Lee Pump pushes 1400 psi @ 3000 rpms (I think its 3000).

Seth

standard is roughly 1250 to 1350psi

ok, so how much psi is needed to move a ram big enough to work a bender say a 2.5 x 24 ?

- jack

Several years back i tried to run a JD2 off of my stock pump on my Chevy engine and it didn't have enough power to bend 2" 120 wall.
Maybe if you boosted the pressure but not stock.