Installed the tranny and t-case ( pain in the ass ) and forgot to put fluid in the torque converter. How fawked up will it get if i fill the pan and start it? Can i prime it somehow so fluid gets into the converter?

Add half reccomended ammount of fluid, start it up, shift into reverse then drive then reverse then park, [b]DO NOT REV THE ENGINE WHILE IN GEAR AND ONLY LEAVE IN GEAR FOR A FEW SECONDS!
Shut down the engine, add the rest of the fluid, re-start the engine, go through the R-D-R-P again, leave the engine running, check your fluid level (both sides of the dipstick!), top off as needed and you're done.

it also might whine or screeeem dont be alarmed about that

yea - not a real biggie - I did that myself - had some pinging in the TC for a little bit due to trapped air, but that worked its way out...

Thanks, that's exactly what i wanted to hear.

I should be able to confirm shipment on the balance in a few hrs... will advise
Ken

Thanks for all your help G02guy. Let me know when you get back to Cedar City and dinner and brew is on me.