Evening, I poked around with some key word searches but to no avail..
Anybody got a crossover part# for the 2-5/16" 1/2x20 H1 wheel stud for NAPA/Autozone......?

Without knowing the knurl diameter and shoulder this is all I have listed that are close to the length...

NAPA

641-4260
Thread 1/2"x20
Length 2 5/64"
Knurl Diameter .628"
Shoulder 7/16"

641-4262
Thread 1/2"x20
Length 2 59/64"
Knurl Diameter .684"
Shoulder 9/16"

641-4221
Thread 1/2"x20
Length 2.24"
Knurl Diameter .618"
Shoulder .642"

641-1602
Thread 1/2"x20
Length 2 3/32"
Knurl Diameter .565"
Shoulder .45/64"

Yo, thanks! Knurl dia. 9/16", sholder 5/16".... Maybe the 641-1602 with a little "a la peanut butter sandwiches"....cut knurl and run a die down over...Maybe I culd space it on the back side untill I get a boat load of um...mmm, I see knurl length appears to be the same though... no spacing...

The parts book says part number- 6017026 STUD-1/2-20 X 2.1L DORRLT PLATE around $8.50 each.
If you do figure a crossover part I need a couple hundred of them.
Blair

I drove all over the island today, found a lot of wheel studs but not exactly what I needed... I ended up going w 3 of these,

641-1602
Thread 1/2"x20
Length 2 3/32"
Knurl Diameter .565"
Shoulder .45/64"

I tuned the sholder down and slapped a couple grade 8 flat washers under them untill I get some new ones, coulda ran a die down um but I was too lazy... I will keep looking though, I'll eventually end up replacing them all.... There must be a cheaper source...

I spoke w a guy who use to sell for Dorman, he said these look like a Dorman stud, inturn I called the tech line @ Dorman and we found these (the .535 knurl dia is a question) http://www.dormanproducts.com/p-22263-610-138.aspx
I know these are not the ideal length but for me they will work, I'm running my H1's on my DD so no runflats or beadlocks here... I'm not familiar with what length you need for assembly when using beadlock inners or run flats; maybe you can pull the halfs together w 3-4 longs and use these after and for replacements when bolted together...? Available@ Autozone, Carquest, Summit, etc.... Summit looks like $15 for 10 or $1.99@ Autozone
http://www.autozone.com/autozone/parts/Wheel-Stud/_/N-6o25b?filterByKeyWord=+610-138&fromString=search&newYmme=true
http://www.summitracing.com/parts/RNB-610-138/

I THINK I FOUND IT!! http://www.sax-express.com/ShowItem/101640%20Wheel%20Assembly%20Bolt%20For%20Two%20Pie ce%20Steel%20Wheel.aspx
Yup! Just ordered 12, Fu$! Kascar!!

dragging this one up

610-163 looks closest other then they are shorter
knurl is .545
the nuts are 22cents each at fastenal

anyone have a better number?
I am going to try the chevy stealership with OEM numbers too