wanderingwillys
11-09-2002, 04:58 PM
I searched some and found this:
link (http://www.pirate4x4.com/forum/showthread.php?s=&threadid=57305&highlight=21+spline+toy+jeep)
I am trying to figure out if the shaft diameter is the same so that the toy case (or duals) can be used behind a jeep AW-4 - Obviously some type of adapter needs to be done but I am wondering what the toy case's input shaft is like and what the bolt pattern is like :flipoff2:
Help out a "dyed in the wool jeep guy" to see the toyota light!
I am building a buggy based loosely on a 43' MB sheet skin that has been pretty chopped up - WB is going to fall in the 110 - 115" range with a 4.0l/ AW4/ cases to be determined (toy or a 242 reduction box with a D300 or same reduction box to a divorced 205
Frame is being built from scratch so the room is there just need to see what I can make work; I would like the toy stuff as it is very modular and proven. But all options are still open... ;)
Matt
link (http://www.pirate4x4.com/forum/showthread.php?s=&threadid=57305&highlight=21+spline+toy+jeep)
I am trying to figure out if the shaft diameter is the same so that the toy case (or duals) can be used behind a jeep AW-4 - Obviously some type of adapter needs to be done but I am wondering what the toy case's input shaft is like and what the bolt pattern is like :flipoff2:
Help out a "dyed in the wool jeep guy" to see the toyota light!
I am building a buggy based loosely on a 43' MB sheet skin that has been pretty chopped up - WB is going to fall in the 110 - 115" range with a 4.0l/ AW4/ cases to be determined (toy or a 242 reduction box with a D300 or same reduction box to a divorced 205
Frame is being built from scratch so the room is there just need to see what I can make work; I would like the toy stuff as it is very modular and proven. But all options are still open... ;)
Matt