Just trying to design a bumper and I dont have a winch in front of me to model. Thanks! (BTW, Im using Solid Edge v12)

Warn has exterior dimensions on there site...I think that's as detailed as you are going to get.

yeah i already was looking at those, but they dont help with the depth of those features... it says that its 6.5" deep, but not every feature goes back that far.

I suppose you could email warn and ask them

Or tell us what winch you need specs on,, bet somebody has one and could take a tape to it.

well in that case if someone could get the following from a HS9500i:

motor diameter
clutch housing diameters (big and small)
length of the clutch housing

Side profile of the winch from base to top of integrated solenoid housing.

If anyone can do that that would kick ass.... here's a :beer: :D

Best I can do...

http://www.warn.com/warn.nsf/Images/HS95iLine.gif/$File/HS95iLine.gif

Originally posted by Fullreversal
well in that case if someone could get the following from a HS9500i:

motor diameter
clutch housing diameters (big and small)
length of the clutch housing

Side profile of the winch from base to top of integrated solenoid housing.

If anyone can do that that would kick ass.... here's a :beer: :D

All specs are by tape, in the rain,, If you need someting closer, ask, I'll go back out and take the calipers.

motor- 4.75

clutch minor dia-4.00, 2.50 long
clutch Major dia-5.125, 2.00 long
Side shot.. at the widest point , center of the clutch, 6.00, starts to taper at the top of the clutch, down to 3.00 at the top of the winch.

http://www.superford.org/registry/users/208/144/PICT0114.JPG
http://www.superford.org/registry/users/208/144/PICT0118.JPG

Awesome! thanks B78

:beer: :beer:

:D