jimmyrig
04-08-2011, 10:06 AM
This was going to be used for a project that didn't develop...So now I need to make my money back.. SOLD
Consider trade for built Yota or one tons
I bought this from another PBB member a couple of months back. Everything is the same except all the brackets have been removed to be set up however you want.
Sold plus the ride
Driver drop
here is the original ad and details
-complete housing 3"x3/8 tubes, hub to hub width is about 66 inches, the pumpkin is offset 24" inches to the center of the pinion to the hub. The ends are the Spidertrax fab'd chromoly with F450 hubs on a 6 x 6.5 bolt pattern (chev pickup), it has four link tabs, shock mounts, sway bar mounts out of 3/8 thick material. I used the Spidertrax high steer billet steel steering arms. I have two set of inner axles 31 and 35 spline and a set of outers. They are all the 300m material, they were like $3,000.00 dollars alone!!! I used a smaller rotor so I could use a fifteen beadlock but I've got the brand new LW 14" spidertrax rotors, four, along with four new solid 13" rotors and four billet aluminum spidertrax rotor hats. The housing was assembled on a differential jig so everything is true. I paid a little over $6,600.00 plus freight AND labor. I know I'm going to take a beating but cash is king. I can crate it and ship it so that's not a problem. I'd like to get $3500.00 for everything but......
http://pirate4x4.com/forum/showthread.php?t=934070&highlight=
Consider trade for built Yota or one tons
I bought this from another PBB member a couple of months back. Everything is the same except all the brackets have been removed to be set up however you want.
Sold plus the ride
Driver drop
here is the original ad and details
-complete housing 3"x3/8 tubes, hub to hub width is about 66 inches, the pumpkin is offset 24" inches to the center of the pinion to the hub. The ends are the Spidertrax fab'd chromoly with F450 hubs on a 6 x 6.5 bolt pattern (chev pickup), it has four link tabs, shock mounts, sway bar mounts out of 3/8 thick material. I used the Spidertrax high steer billet steel steering arms. I have two set of inner axles 31 and 35 spline and a set of outers. They are all the 300m material, they were like $3,000.00 dollars alone!!! I used a smaller rotor so I could use a fifteen beadlock but I've got the brand new LW 14" spidertrax rotors, four, along with four new solid 13" rotors and four billet aluminum spidertrax rotor hats. The housing was assembled on a differential jig so everything is true. I paid a little over $6,600.00 plus freight AND labor. I know I'm going to take a beating but cash is king. I can crate it and ship it so that's not a problem. I'd like to get $3500.00 for everything but......
http://pirate4x4.com/forum/showthread.php?t=934070&highlight=