I've heard of these prefabbed tight radius steel "donuts". You cut the wedges you need, rotate and weld to make tight turns on your custom exhaust- where can i get them? The local shops can do anything as long as its "duals on a pickup":D

I've seen the 180 eg. pices in Jegs and summit but what I'm looking for is much tighter and you get a full 360 out of each piece.

Anybody?

chassis shop in michigan or somewhere

Ive used the tight mandral U-bends from JCwhip-me I got the aluminized and i think they even had the doughnuts like you mentioned... (been a while)

Ive had trouble finding anything on their web site, but i know its in the catalog, PM me if you need a part # I can look it up when i get home... -yag

Try Grand Prix Racing Parts in T-Town I think they have them in stock. If they do I can pick them up and ship them to you, they're just down the street. 918-836-8487

Jc Whitney has 90's and 45 mandrels. I think The Chassis Shop (http://www.chassisshop.com) has them, but they aren't listed on their website.

try this place:
http://www.burnsstainless.com/
peace
Jw

Thanks everyone- I did find the donuts- pricey though, I called the place in Tulsa, they should have some 2 j-bends in for me tomorrow- with a tight 3" radius.

YB, I'll pay for them, verify they made it in and if you don't mind just grab them and pring to Disney in 12 days. I can wait til then to finish my exhaust.
Thanks,
Ken

not sure if this is what you're wanting or not. but this place has a bigger selection than any place i've found

http://www.stahlheaders.com/Frame%20Tubing.htm

- jack

I'll pick them up and bring them with me.