For those of you running pinion adapters (404 mog) made from stock torque tube, what is the part number for the seal that fits over stock shaft but within torque tube? Any help appreciated

Jake

Come on guys, just need a seal that fits over the torque tube, the outer diameter i can work with, a napa part # or similar would be appreciated, going wheeling and refuse to leak oil up and down the trails, thanks in advance.


Jake

I just took the two parts into a bearing shop and they found something to suit.

52mm ID fits the shaft if I remember correctly, the seal I got was an output shaft seal from a Nissan transfer case and was 70mm OD and about 6mm wide.

Thank you sir, i may have found a possible route but i will definately look into yours, thank you again


Jake