I've got a 1986 Grand Wagoneer N/T rear D44 (LP) with Ford D60 outers and SRW hubs with new bearings (spindles can be bored to fit 35 spline shafts). New Blue Torch Fab truss (1/2" thick) with tie in 5/16" thick diff cover. Added gussets to spindles for added support and ran 1/8" from truss to end of axle (should have been boxed in, I know). Wheel mount to wheel mount measurement - 61 3/4". No gears, carrier or shafts. It is primed and painted black.
Asking $200 picked up in Manchester, NH. I can strap it to a pallet and get a shipping quote if interested or buyer can setup their own (have a shipping dock at work). Buyer pays shipping.
Cut and grinded 45*
setup spindles
spindle welds
truss welds
spindle gussets - they have been cut down flush with the top of the spindle
finished
Asking $200 picked up in Manchester, NH. I can strap it to a pallet and get a shipping quote if interested or buyer can setup their own (have a shipping dock at work). Buyer pays shipping.
Cut and grinded 45*
setup spindles
spindle welds
truss welds
spindle gussets - they have been cut down flush with the top of the spindle
finished