Pirate 4x4 banner

Custom double spline shafts

1K views 6 replies 4 participants last post by  Mike Axle 
#1 ·
30 spline Toyota fronts
35 spline Full float
and lots of weird stuff.
Other spline counts:
24, 27, 29, 31, 32, 35, 36, anything else can be done as well!

30 or 45 degree pressure angle

We've been cutting shafts for many years, using 4340 bar that we machine, and spline in house. Long spline can also be done (toyota rear elockers)

Pricing varies, email or PM for quoting.
 
#4 ·
We figure shaft lengths when we build housings, so we can have shafts and the housing done at the same time, ensuring perfect fit!
 
#6 ·
Yes! Id need a dimensioned drawing, and the mating gears it would spline into to check fit. :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top