Will you guys be making a high steer arm that will tie into the stock knuckle with a bolt through the stock steering hole like an Artec arm ( I believe you guys have an arm like this for the kingpin style)??
My arms sit almost directly over the stock TRE Location and 7" higher from top of original to top of new arm. Best way to know is to take a straight edge and go up 7" from original and check that way. But I am guessing no, with that much backspacing.
I do not have an complete axle here in the shop at this time or I would check
Hey hows it going? This is my first post on this forum. Anyways I am interested in your machining service. I am in Canada. I was wondering if you have shipped to Canada yet and what it might cost me for your service. I have searched locally with not much success. Please let me know. BTW the axles are for a 1996 K1500 sas if that matters.
These knuckles fit nicely in a Large Flat Rate box from USPS That will cost ya around 55$ to me. Usually the cost of shipping back to customer is included in price, but that is to the US only. So there would be an extra $40 to cover that .
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.4K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!