Welcome To Pirate 4x4
General 4x4 Forums
4x4 Tech Forums
Brand Specific Tech
Land Use and Trails
Pirate 4x4 Community
Marketplace
Member for 30+ days with a minimum of 30 posts required to participate.
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Forum Support
Off Topic Discussions
Regional Forums
Latest Posts
-
Started my 2005 LJ rubicon with 125,000kms on it the other day and was pleasantly met with the sound of a half seized OPDA. Pulled it out and the cam gear is pretty worn out and the tips of the teeth are sharp. Looks like I get to replace the cam shaft. Already received my new crown OPDA. Rock...4 replies 3K views
-
Hey Everyone - wanted to share this story with the community at large - I drive a 98 ZJ, 6" lift, 33s, lunchboxes front and rear, IRO Long arms front & rear - trussed HP D30 front axle, trussed 8.8 rear axle etc etc. Not my daily driver, I am a finesse driver, never snapped a u-joint or an axle...4 replies 495 views
-
Hey so the PO of my cj5 put a 2500 rpm stall torque converter into it and I’m wondering if it is the cause of my crawling issues. Whenever I attempt to get up a steep hill or over a large rock the Jeep will not move unless I give it quite a bit of gas. It has a Chevy 4.3l, th350, and np205, with...6 replies 172 views
-
Hi, I'm looking for a pto driven winch. I have a lightly loaded Loadstar 1700 4x4 camper and I want something strong enough to pull it out of the mud or snowy ditch but nothing excessively heavy on the front of my truck. (I'm considering a heavier winch for the bed of the truck, but that's...7 replies 190 views
-
I just retired and I need a trailer, for everything.. To haul my lawn tractor, motorcycles, materials, another truck etc.. I remember thinking the PJ buggy hauler looked tits, but the load capacity is only 7729 lbs.. Any suggestions? Thanks!1 reply 55 views