Pirate 4x4 banner

dana 60 turning help

1K views 3 replies 3 participants last post by  rockbuggy84 
#1 ·
After 30 min of searching Im having a hard time finding any info on how sharp a stock early 80's kingpin d60 knuckles can SAFELY turn without breaking a shaft , is there a measurement of how far out the steering stop bolt should be out of the knuckle or how many deg is safe ? Im adding hydro assist and want to limit the ram with out getting to the danger zone? In the past I have broke front axle shafts when turning but am unsure how to measure or tell when the u joint is binding

any info would be great
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top