|01-12-2007, 11:39 PM||#1 (permalink)|
Join Date: Jun 2006
Member # 73904
Location: Tucson Arizona
5.3 vortec to sm420
Im trying to find the best hydraulic clutch setup for this combination. Advance has everything we need for about 1290.
Too much $$
We would like an external slave, (advance adapters is internal)
a 4.8 or 6.0 flywheel I hear is the only one that will work
a pressure plate, throwout bearing, release bearing, EVERYTHING
Wheres the best place to be looking for vortec clutch parts that dont cost an arm and a leg?
TEAM CROSSED UP #4431
2012 SPONSORS Crossed Up Off Road, ADS Race Shock, Artec Industries, Applied Hydrographics
2013 KOH Qualified
2012 DIRT RIOT SOUTHWEST SERIES CHAMPION
2012 KOH 9TH PLACE
2012 DIRT RIOT 1ST PLACE TUCSON AZ
2011 ROCK SPORTS CHALLENGE 4TH PLACE
2011 KOH FINISHER
2011 LCQ 13TH FINISHER
2010 KOH PARTICIPANT
I'd Rather Be... Crossed Up
|01-14-2007, 05:37 AM||#2 (permalink)|
Vortec Scout II
Join Date: Jun 2005
Member # 48545
Location: Arkansas / "The Stan"
Blog Entries: 1
Car-Part.com--Used Auto Parts Market. Or E-bay!
GM Parts Direct: Your direct source for Genuine GM Parts
For new stuff.
I would also look here for answers as well http://www.performancetrucks.net/forums/
'73 Scout II Vortec 6.0L 4L65e np241
'73 1210 Travelette SV392, T-34, 60/14bff 4.56's 35's
'01 VW Beetle TDI-50mpg or better!
GM Gen III/IV V8 swap info
TECH: Gen III/IV "LS motor" to Early GM Auto Trans
Last edited by Bo185; 01-14-2007 at 05:40 AM.