Body Lift on 97 Tahoe - Pirate4x4.Com : 4x4 and Off-Road Forum

CJ7_Bob · 09-29-2001, 03:48 PM

My wife wants a 2 to 3" body lift installed on her 97 Tahoe, more than likely a 2". Was just wondering how much is in volved in the installation before I order one. Thanks

4x4jbm · 09-30-2001, 07:15 PM

A LOT! Don't do it. Get here a suspention lift.

scouter77 · 10-03-2001, 05:24 AM

I have the performance accessories 3" on my 95 (2wd) it was cake. I hate it though and am probably takin it off. I would go w/ a susp lift. If yours is 2wd too get the fabtech spindles and blocks or coil spacer and rear blocks (cheaper route). The spindles keep the same geometry and everything it is basically a spacer. I know <IMG SRC="smilies/rainbow.gif" border="0"> reply from me and all but....

09-29-2001, 03:48 PM	#1 (permalink)
CJ7_Bob Registered User Join Date: Nov 2000 Member # 2359 Location: New Mexico Posts: 39	Body Lift on 97 Tahoe My wife wants a 2 to 3" body lift installed on her 97 Tahoe, more than likely a 2". Was just wondering how much is in volved in the installation before I order one. Thanks __________________ [b]83 CJ7[/b] 4" Superlift, 2" Body Lift, 33" MT's, 4.56's, Superior One Piece Axles, Rear Detroit Locker, PowerTrax No-Slip Front, Warn X8000I, HEI, Motorcraft 2100, 5 Speed, Dana 300 Twin Stick, York Air, Arizona Driveline

09-30-2001, 07:15 PM	#2 (permalink)
4x4jbm Registered User Join Date: Mar 2001 Member # 3646 Location: Antelope, CA, 95843 Posts: 400	A LOT! Don't do it. Get here a suspention lift. __________________ WHAT THE HELL IS THAT?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-03-2001, 05:24 AM	#3 (permalink)
scouter77 Registered User Join Date: Apr 2001 Member # 3988 Location: PHX,AZ Posts: 2,076	I have the performance accessories 3" on my 95 (2wd) it was cake. I hate it though and am probably takin it off. I would go w/ a susp lift. If yours is 2wd too get the fabtech spindles and blocks or coil spacer and rear blocks (cheaper route). The spindles keep the same geometry and everything it is basically a spacer. I know <IMG SRC="smilies/rainbow.gif" border="0"> reply from me and all but....