 |
|
|
 |
|
|||||||
| Register | Blogs | FAQ | Members List | Social Groups | Calendar | Mark Forums Read | Premium Memberships | Auto Loans |
 |
|
|
Share |
| Thread Tools | Display Modes |
08-26-2001, 08:49 AM
|
#1 (permalink) |
|
Registered User
Join Date: Jul 2001
Member # 5661
Location: West Hempstead, LI
Posts: 57
|
HELP!!! 700r4 Problem
I'm installing a used/rebuilt 700r4 in my Jeep and I needed to remove the u-shaped shifter bracked from the tranny, so that can install the B&M plate. With very little force I managed to snap the stud holding on the bracket. The bracket has a square that locks on the tranny, the stud & nut just keep it in place.
Can I drill a hole and use a short self taping bolt? How deep can I drill w/o screwing up the tranny? Thanks Mark F <IMG SRC="smilies/eek.gif" border="0">
__________________
98 TJ 4.5" RE LA, 35" lots of armor |
|
|
|
08-27-2001, 12:22 PM
|
#2 (permalink) |
|
Zeus of the Sluice
Join Date: Mar 2000
Member # 481
Location: San Jose, CA, USA
Posts: 3,850
|
Like you said it just holds it on to keep from falling off. Should be ok. I think the linkage is easily replaced however. Need to remove the pan and take a look. I believe there is an s link inside that will allow it
to be removed. Jason <IMG SRC="smilies/smile.gif" border="0">
__________________
Click Here For Awesome Metal Fabrication Equipment From BAILEIGH INDUSTRIAL |
|
|
|
| Sponsored Links |
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -7. The time now is 12:09 AM.