I found some information posted on other threads, but I'm still a little foggy.....
I have a 4L60e out of a 96 corvette, I'm looking at getting a NP241c. The tranny has a long tailcone, when removed the spline is about 7 3/8" long. As long as both are 27 spline, is all I need a 4 bolt tranny side to 6 bolt TC side adapter like this one below on ebay ?
http://cgi.ebay.com/ebaymotors/CHEV...1012?IMSfp=TL0910121510001r32539#ht_598wt_958
I'm assuming i would just remove the exsisting tail cone on the tranny and bolt this adapter up, if this is correct the spline on the tranny would stick out 3 7/8" past the adapter, does this all fit in the transfer case input spline?
Been out of 4wd's a long time....
Thanks,
Rick
I have a 4L60e out of a 96 corvette, I'm looking at getting a NP241c. The tranny has a long tailcone, when removed the spline is about 7 3/8" long. As long as both are 27 spline, is all I need a 4 bolt tranny side to 6 bolt TC side adapter like this one below on ebay ?
http://cgi.ebay.com/ebaymotors/CHEV...1012?IMSfp=TL0910121510001r32539#ht_598wt_958
I'm assuming i would just remove the exsisting tail cone on the tranny and bolt this adapter up, if this is correct the spline on the tranny would stick out 3 7/8" past the adapter, does this all fit in the transfer case input spline?
Been out of 4wd's a long time....
Thanks,
Rick