#1
·
May 12, 2010
This sweet candidate for overhaul was traded to my in November 09
409ci BBC
Dana 60 front
14 FF rear
currently has stock T 350 NP 203 for now
12, 1 1/4" ruff stuff heims 4, FK 1 1/4
lower links are 2 1/4" OD x 3/8" wall dom
Upper are 1 3/4" x .120 DOM
#2
·
May 12, 2010
Ok so I am going to post all my pics up to date and save to typing for later because after photofuckit.com I am tiered.
#7
·
May 12, 2010
I know there is a few segments missing i will try to get them up soon.
#10
·
May 12, 2010
What I saw looks good, I got tired of scrolling half a mile to see the pics. :flipoff2:
#16
·
May 12, 2010
Yes ,I used the inside half's off a set of 16.5. I have about 12 hrs into doing this.
0
Reply
#12
·
May 12, 2010
Looks good. Kinda resembles the k5 "pre-mudder" petersons built
#13
·
May 12, 2010
Looks really good. I would love to build a K5 like this some day :smokin:
#18
·
May 12, 2010
(Edited)
Look's similar to theirs and that's what I was tying for ,but I made every thing on this pig in my garage!
0
Reply
#19
·
May 12, 2010
how was it mounting to the frame with the 4 link? looks clean!!!!
#44
·
May 14, 2010
Very easy on a blazer they have almost a flat bottom frame . The tranny cross member had to go .
0
Reply
#20
·
May 12, 2010
Sure I would look at other build's and take some ideas with me to the shop but after that it was all cardboard and cutoff wheels for me .
#21
·
May 12, 2010
Looking great! Keep up the great fab work! And great choice in beer. BL lime is the best!
#31
·
May 13, 2010
rear end is = length @ 40"
fronts are 36" = length All measurement are eye to eye
1
Reply
#23
·
May 12, 2010
Id like to see a picture of the frame link mounts if you got one. Nice work.
#24
·
May 12, 2010
Nice work, like the rims, especially.:smokin: keep the pics coming!
#25
·
May 13, 2010
how well does your front pass tire clear the upper link at full turn/articulation?
#26
·
May 13, 2010
What is the big upside-down chrome U-shaped thing on the front of the engine? I've never seen anything like that before.
Sweet build. Coming along nicely.
#28
·
May 13, 2010
Looks like an old set of Edelbrock elephant ears (motor mounts).
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.