Pirate 4x4 banner

Connector Fun

663 views 3 replies 2 participants last post by  sylgeist 
#1 · (Edited)
Connector Fun [SOLVED]

I'm trying to get my 5.3 swap done and I'm stuck on the dbw pedal. I need to flip a couple wires in the connector and I can't figure out how to release the terminals.

It's the 6 pin flat connector - Delphi GT 150. I know there is a special removal tool but it looks like it's just a flat blade like the metripak/weatherpak tool. Any advice?
 
#2 ·
try a paperclip, its about the same size as the tool. just remove the clip on top the connector and theres a tang that catches inside the connector. look down in the connector, you shoud be able to see it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top