AMC to Ford T18 Clutch,bellhousing setup - Pirate4x4.Com : 4x4 and Off-Road Forum

Domer1 · 11-08-2010, 09:43 AM

I have everything to bolt a Ford T18 to a Jeep AMC 258 motor. A stock 258 bellhousing w inspection cover, 258 recently surfaced flywheel, flywheel bolts, bellhousing bolts, pressure plate bolts, 258 starter, correct splined new ACDelco(Sachs) 381143 RAISED DIAPHRAGM 10.5" disk X 10 spline X 1 1/16 shaft clutch for T18 Ford spline. Also have the correct Novak #A6932A pilot bushing to fit AMC crank.
200 for everything
Located in Glendora CA

Domer1 · 11-18-2010, 10:11 AM

ttt

Domer1 · 03-04-2011, 10:13 PM

ttt

Domer1 · 03-29-2011, 10:26 AM

Ttt

11-08-2010, 09:43 AM	#1 (permalink)
Domer1 Wheeler Join Date: May 2004 Member # 30678 Location: Glendora Posts: 266	AMC to Ford T18 Clutch,bellhousing setup I have everything to bolt a Ford T18 to a Jeep AMC 258 motor. A stock 258 bellhousing w inspection cover, 258 recently surfaced flywheel, flywheel bolts, bellhousing bolts, pressure plate bolts, 258 starter, correct splined new ACDelco(Sachs) 381143 RAISED DIAPHRAGM 10.5" disk X 10 spline X 1 1/16 shaft clutch for T18 Ford spline. Also have the correct Novak #A6932A pilot bushing to fit AMC crank. 200 for everything Located in Glendora CA Attached Images Last edited by Domer1; 11-18-2010 at 10:10 AM. Reason: added pics

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-18-2010, 10:11 AM	#2 (permalink)
Domer1 Wheeler Join Date: May 2004 Member # 30678 Location: Glendora Posts: 266	ttt

03-04-2011, 10:13 PM	#3 (permalink)
Domer1 Wheeler Join Date: May 2004 Member # 30678 Location: Glendora Posts: 266	ttt

03-29-2011, 10:26 AM	#4 (permalink)
Domer1 Wheeler Join Date: May 2004 Member # 30678 Location: Glendora Posts: 266	Ttt