400 ford engine mount dimensions - Pirate4x4.Com : 4x4 and Off-Road Forum

mustange70 · 08-14-2011, 09:44 AM

I'm hoping someone could help me out here, I'm going to be doing an engine swap soon into a new project (my 400 stroker out of the race truck into a ranger) for mud drags/bogs, and I'm trying to get material and as many brackets pre ordered as possible as my time line is going to be short. That said I'm hoping to get the dimensions and bolt spacing of the motor mounts for a 400 ford, anyone help me out? a quick picture or paint sketch or something would work.

Thanks.

Stpaulies · 08-15-2011, 10:54 AM

Your timing is really good. i just pulled mine out this week. here is a 79' 400. took some measurements for ya.

Stpaulies · 08-15-2011, 11:12 AM

pick is hard to see. here is an easy to read rough drawing.

mustange70 · 08-15-2011, 05:48 PM

thanks, that's greatly appreciated

08-14-2011, 09:44 AM	#1 (permalink)
mustange70 Registered User Join Date: Jan 2005 Member # 41097 Location: Calgary Posts: 2,109	400 ford engine mount dimensions I'm hoping someone could help me out here, I'm going to be doing an engine swap soon into a new project (my 400 stroker out of the race truck into a ranger) for mud drags/bogs, and I'm trying to get material and as many brackets pre ordered as possible as my time line is going to be short. That said I'm hoping to get the dimensions and bolt spacing of the motor mounts for a 400 ford, anyone help me out? a quick picture or paint sketch or something would work. Thanks. __________________ 90' C350 AKA 4 door 1 ton Bronco 96' Ranger: kings, EMF parts, 800hp SBF

08-15-2011, 05:48 PM	#4 (permalink)
mustange70 Registered User Join Date: Jan 2005 Member # 41097 Location: Calgary Posts: 2,109	thanks, that's greatly appreciated __________________ 90' C350 AKA 4 door 1 ton Bronco 96' Ranger: kings, EMF parts, 800hp SBF

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-15-2011, 10:54 AM	#2 (permalink)
Stpaulies Registered User Join Date: Jul 2011 Member # 195503 Posts: 116	Your timing is really good. i just pulled mine out this week. here is a 79' 400. took some measurements for ya.

08-15-2011, 11:12 AM	#3 (permalink)
Stpaulies Registered User Join Date: Jul 2011 Member # 195503 Posts: 116	pick is hard to see. here is an easy to read rough drawing.