body lift ????'s - Pirate4x4.Com : 4x4 and Off-Road Forum

muddogg · 10-06-2001, 01:39 PM

I am putting it on the ford below, I know guys, I should put a BD lift on , but I am doing it anyways. I was wondering how to get around the gas tank to get to the two front bed bolts, and also what to do about the front bumper, it is stock, but I need to either push it out or raise it up, what do you suggest and how? thanks guys, I need to get this done be tommarrow!

pavelow · 10-07-2001, 12:50 AM

Its called "slick fingers" thats the way I did my buddies......

Unless you wanna drop the tank.

slvregl · 10-07-2001, 06:22 AM

My Ranger kit came with 2 flat plates with offset holes to raise the front bumper. Make sure you measure carfully and you can do the same thing.

10-06-2001, 01:39 PM	#1 (permalink)
muddogg Registered User Join Date: Sep 2000 Member # 1629 Location: Nehalem, Oregon, U.S. Posts: 359	body lift ????'s I am putting it on the ford below, I know guys, I should put a BD lift on , but I am doing it anyways. I was wondering how to get around the gas tank to get to the two front bed bolts, and also what to do about the front bumper, it is stock, but I need to either push it out or raise it up, what do you suggest and how? thanks guys, I need to get this done be tommarrow! __________________ '81 F-150 with good sh*t!, WANTED 39.5 boggers!

10-07-2001, 12:50 AM	#2 (permalink)
pavelow Registered User Join Date: Apr 2001 Member # 4225 Location: Panhandle........Fl Posts: 476	Its called "slick fingers" thats the way I did my buddies...... Unless you wanna drop the tank. __________________ Wanna touch it?

10-07-2001, 06:22 AM	#3 (permalink)
slvregl Wheeler Join Date: Apr 2000 Member # 698 Location: Dixon, Ca. USA Posts: 343	My Ranger kit came with 2 flat plates with offset holes to raise the front bumper. Make sure you measure carfully and you can do the same thing. __________________ 1970 Bronco, 5.0, NP435, Dana 20 W/Rock Eater 4.86 gears, 35 BFG Muds, Currie 9in w/Detroit, Dana 44 w/ARB Does anybody have a cure for Bronc-ITIS?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode