Pirate 4x4 banner

Corner Cylinders Aren't Firing

432 views 2 replies 3 participants last post by  SonicDonkey 
#1 ·
All right ya'all....I need some help with this one.

1997 F250 H.D. 4x4 with a 5.8, automatic.

Problem is as follows:
Bought truck recently for a song (I wonder why??)

Truck ran geat for my test drive, and only for roughly 10 miles after that.

The truck kicked down a gear to go up a hill, and immediately started to sputter, and throw enough smoke out to kill half the skeeters in the Poconos.

Upon diagnosis, only the inside cylinders on each side are firing. The corners are not firing. I have gas, but no spark.

I replaced Cap, Rotor, Plugs and the Ignition Module, but none of it did a damn bit of good.

I'm feeling dumber than usual with this one, so all and any help would be greatly appreciated.

Thanks Ya'all,

Rusty
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top