Pirate 4x4 banner

what soud i do?

664 views 6 replies 4 participants last post by  desert runner 
#1 ·
i have a 88 bronco that i cant renew the tag do to one of the PO's...

i want to make it into a designated trail/recovery rig. the palns are below:

6inch lift
axle swap/upgrade (if needed)
36"interco swampers
propane injection (or cumin swap) which would be better?
bumpers
front and rear winch


what do you think i should do with the motor?
it is a 300 CID inline six, multipoint injection.

the propane sounds like a great idea... which would be better?
 
#3 ·
If the 300I-6 runs good I would just leave it in there(they are pretty good motors and u can build one torquey bitch)If the 300 is too old and crappy I would build a 351w,it will bolt-up to your trans and would be an easy swap
 
#4 · (Edited)
are you sure that it will.... i have the 4speed with granny... that would be wicked... can anyone say a ticket for 120 plus comming?

the six that is in there right now has several issues. but still a strong engine, tows a 25 foot steel trailer with a small backhoe on it without trying.

for the problems:
the whole exaust needs to be fixed, tune-up, oil, water pump, throttle position sensor, egr, (No smog pump), need the driver side motor mount (just replaced the passenger side), if there is anything else that i can think of i will post it...

trying to decide what would be cheaper...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top