high pinion dana 60 question - Pirate4x4.Com : 4x4 and Off-Road Forum

crazy_mtb_2002 · 01-11-2009, 03:36 PM

Been searching for a couple hours now, and never found any good info,
looking to see what a u bolt on an hp 60 looks like that sits beside the pumpkin have it all mocked up underneath my truck at the moment, and hoping to see what other guys have done, or what a stock setup looks like, thanks

crazy_mtb_2002 · 01-11-2009, 03:44 PM

finally found a picture in a build thread of it bolted straight to the housing, i'll see what i can muster up, thanks

mj · 01-11-2009, 05:20 PM

stock setup has a cast cap under the axle to locate the ubolts

94stepsideford · 01-11-2009, 06:02 PM

Yup

crazy_mtb_2002 · 01-11-2009, 06:34 PM

perfect, thanks alot, mangled a u bolt for the time being to mock it up, but i'll have to make something like that to work.

rockinranger62 · 01-13-2009, 05:13 AM

Quote:

Originally Posted by 94stepsideford

Yup

I have been looking for one of these forever. It was hard because I didn't know what I was looking for.

Does anybody have a source for these cast plates?

01-11-2009, 03:36 PM	#1 (permalink)
crazy_mtb_2002 Registered User Join Date: Feb 2007 Member # 87514 Location: Parksville BC, Canada Posts: 50	high pinion dana 60 question Been searching for a couple hours now, and never found any good info, looking to see what a u bolt on an hp 60 looks like that sits beside the pumpkin have it all mocked up underneath my truck at the moment, and hoping to see what other guys have done, or what a stock setup looks like, thanks

01-11-2009, 06:02 PM	#4 (permalink)
94stepsideford Registered User Join Date: Oct 2004 Member # 36399 Location: Hinesburg, VT Posts: 3,147	Yup __________________ 94 F-150 Stepside. BGTL 12" lift, 1-tons, 39" 'roks 95 F-150 6" of lift, SAS 35" BFG's

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-11-2009, 03:44 PM	#2 (permalink)
crazy_mtb_2002 Registered User Join Date: Feb 2007 Member # 87514 Location: Parksville BC, Canada Posts: 50	finally found a picture in a build thread of it bolted straight to the housing, i'll see what i can muster up, thanks

01-11-2009, 05:20 PM	#3 (permalink)
mj Registered User Join Date: Oct 2000 Member # 1919 Location: BC Canada Posts: 7,547	stock setup has a cast cap under the axle to locate the ubolts

01-11-2009, 06:34 PM	#5 (permalink)
crazy_mtb_2002 Registered User Join Date: Feb 2007 Member # 87514 Location: Parksville BC, Canada Posts: 50	perfect, thanks alot, mangled a u bolt for the time being to mock it up, but i'll have to make something like that to work.