Pirate 4x4 banner

86 HP 60 measurment

607 views 3 replies 2 participants last post by  sickford 
#1 ·
OK tried this is gen 4x4 but no luck. I need the vertical measurment from the center line of the axle tubes to the high steer arm mounting surface on a 86 hp 60. Building a truss for my steering ram and forgot my measurement. Thanks
 
#3 ·
ok -


so from the axle center to the top inside of the knuckle ( the lowest point on the knuckle ) 4 3/4"

to the top inside of my balistic arms just over 5 7/8 ( arms are around 1 1/8" thick


to the tierod ends - around 7







and a pic
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top