Would any of you guys with full width/non-narrowed 85-91.5 F350 Dana 60's under your early Broncos be able to take a measurement or a picture for me?
I'd like to figure out where the center/pinion would be left to right. Need to make sure it wouldn't smash into my oil pan and also would like it to clear my new exhaust.
I've got a 93 front ford 60 and from the top center of the balljoint to the center of the spring center pin is 8". From the spring center pin to roughly the center of the pumpkin is about 9". Hope that makes sence...
Don't even think about it just build that sick ass 609 you were talkin about :flipoff2:
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.4K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!